How To Make A Waterfall Bong In 10 Easy Steps

Waterfall bong’s are one of the strongest ways to enjoy a smoke without vaporizing or using a concentrate. This can be easily ramped up to a much more elaborate DIY project. It’s very easy to take the proof of concept of the water drawing air through your bowl and apply it to many different waterfall approaches. You are only limited by your imagination. If you have any problems or comments feel free to drop us a line in the comments below.

What you need

  • An empty bottle w/ cap
  • A socket from any socket set (this will be your bowl)
  • A knife or other sharp object
  • Tape, glue, or other adhesive
  • A lighter

Start with a knife and heat it up:

This makes it really easy to create an even hole in the thick plastic cap in the next step. After you fully heat up the top of the knife move on to number 3

Apply pressure and turn the knife into the cap creating a 2-5 MM hole in the top

This may be a little tough at first. If it doesn’t cut right through, then heat the knife back up and try pushing while rotating it back and forth

Using the same knife create a hole on the lower portion of the bottle

You just need a small hole 5 mm to let water escape (generally around where the bottle starts to groove)

Align the socket to the hole you created in the cap

This way the air freely flows through the ‘bowl’ and makes a nice flow for drawing in the smoke

Seal the socket onto the cap using tape/glue/adhesive

Make sure you get a good seal

This will create the most powerful hits and the best pull from the marijuana.

Pack your bowl

Fill the bottle with water taking care to plug the hole in the bottom with your finger

Put on the cap and light your bowl while letting your finger go from the hole

Enjoy!